Ipv6 Cisco Training: How Is Eigrpv6 Different From Eigrpv4?

Now, if you’re new to the field of network computing, you probably feel that it is quite fascinating, and it is very exceptional, if we try to understand the different Interior Gateway Protocol (IGP’s ) packages can be used to display information from a network.

If you feel that all do not worry, you’re not alone, I felt the same way. That’s why I wrote this article to help you quickly the main differences between EIGRPv6 and EIGRPv4.

In a word, the whole operation and characteristics EIGRPv6 are always the same as EIGRPv4. But EIGRPv6 not EIGRPv4 as follows:

• EIGRPv6 is (on) directly to the interface of the Cisco router, which means may EIGRPv6 (activated) on an interface without the router configuration (for sale) in the world is the IPv6 address of the interface and without the “network” while the command is in the router configuration router.

• Similarly, at the configuration (s) EIGRPv6 on a Cisco router, routing EIGRP must be configured (assigned), with a “router-id” (with the configuration of the router router-id “), if a router – id “is not configured (assigned), routing EIGRPv6 not start.

• Routing EIGRPv6 a “shutdown” feature, meaning EIGRPv6 routing does not start until the routing process was “no shutdown” mode. (by typing “no shutdown” command while the router is in configuring the router)

• In addition, debt Interfaces; EIGRPv6 must not be configured.

• Finally, EIGRPv6 the configuration of the router prefix-list distribute-list “to filter and route the configuration of the route filter” road-map “is not supported.

I invite you to visit my site were you can find the latest information on Cisco IPv6 Design and Implementation Techniques.